Get started with your new
iXoundWear™ Sport Cap for Nano

Recommended installation - step by step

This page is printer friendly.
Print a copy for future reference.

Before you start...

Place in front of you the following elements: your new iXoundWear™ cap, your earbuds of choice, your iPod® Nano and one of the two wire-spools provided with the cap.


Step 1

Wind up the headset cord around the wire-spool. Give the right earbud wire an additional turn (in order to make it shorter). The length of wire left between the headset plug and the wire spool should be 2" (50 mm). The two stretches of wire left between the earpieces and the wire-spool should measure respectively 4.5" (115 mm) for the right one and 9.5" (240 mm) for the left one.


Step 2

Push the wire bundle inside the wire pocket.
Slide your iPod® Nano into the player pocket.
Connect the headset plug to the mini-jack at the bottom of your iPod®.


Step 3

Open the back Velcro® strap. Run the left earbud wire along the strap. Close the strap.


Step 4

Stretch the elastic loop (internally located next to the Velcro® strap) and pass the left earbud through it (the loop supports the wire and makes the left earbud fall next to the left ear).


Step 5

Done! Put it on and plug in your earbuds.
Enjoy your new iXoundWear™ cap.


iXoundWear, Inc.© 2013 - iPod® is a trademark of Apple Inc., registered in the U.S. and other countries. Shuffle™ is a trademark of Apple Inc.

The works of authorship contained in this document including, but not limited to all design, text and images, are owned, except as otherwise expressly stated, by iXoundWear, Inc. and may not be copied, reproduced, transmitted, displayed, performed, distributed, rented, sublicensed, altered, stored for subsequent use or otherwise used in whole or in part in any manner without the prior written consent of iXoundWear, Inc., except to the extent that such use constitutes "fair use" under the Copyright Act of 1976, and except for one temporary copy in a single computer’s memory and one unaltered permanent copy to be used by the viewer for personal and non-commercial use only.